Buy Repair Seal Kit for the Spectra Power Survivor 40E watermaker, with free delivery to mainland UK. 

PURPOSE OF THE KIT. 

The Repair Seal Kit should be installed after 1000 hours of operation. It should be installed regardless of whether

there is leakage or a reduction of fresh water. Learning to perform this procedure will ensure optimal performance

of your watermaker.

INSTALLATION INSTRUCTIONS. 

Over time, the dynamic Seals and O-rings in the PowerSurvivor 40E will wear. The Repair Seal Kit contains the

major seals and O-rings that should be replaced to improve operating efficiency. It also contains new check valve

poppets, springs, and drive oil which should be replaced simultaneously. This Repair Seal Kit should be installed

after roughly 1000 hours of operation. It should be installed regardless of whether there is leakage or a reduction

of fresh water. Learning to perform this procedure will help users ensure optimal performance.

Before beginning the Repair Seal Kit procedure, note the following precaution:

1. Keep the work area clean and clear of dirt, hair, and other contaminants.

2. Avoid scratching Pump Components when removing or replacing O-rings.

3. All seals and O-rings should be lubricated with silicone grease. Never use petroleum-based lubricants

as a substitute.

4. When installing O-rings, do not roll or twist them.

NOTE: Average time to replace all seals is 1 hour. If you are performing this maintenance for the first time, expect

it to take 3 hours.

CONTENT OF THE KIT. 

• Silicon lubricant

• Locktite

• Hose barbLubricating oil

• Small parts

TOOLS REQUIRED. 

• Piston Seal Installation Tool – supplied with kit

• 1/2-inch open-end wrench

• 1/4-inch Allen wrench

• 5/32-inch Allen wrench

• 5/8-inch open-end wrench

• small flat-bladed screwdriver

• needle-nosed pliers

• medium channel lock pliers

• small scissors